SE100 eDP (embedded Display Port/5.4G) Signal Generator
ISX Developed Products
Flat Panel Display Inspection Device
Present the best inspection solution to promote efficiency and precision of FPD production such as LCD, OLED etc.
SE100 eDP (embedded Display Port/5.4G) Signal Generator
SE100 is an eDP output signal generator supporting modules for such as ultra book and tablet which has eDP 5.4G interface and pattern editor software . This is the most appropriate device for high resolution and high-speed transmission modules.
Network Function
Corresponding to network, pattern data and updated firmware are acquirable from server such as NAS via LAN.
Editable Pattern and Timing
According to the test environment, pattern creation and timing setting are freely available by attached editor software.
Supporting 4K2K/60Hz modules
2 DisplayPort outputs enable simultaneous lighting and broaden ways of inspection or evaluation.
Specification
8 bit output corresponding 4-lane DisplayPort 5.4Gbps supported
eDP setting, RGB 1.72/2.7/5.4Gbps supported
2 DisplayPort mounted
Embedded programmable power supply of 2.5-13V/5A for LCD module driving
Patterns and timings editable
AUX communication program of DisplayPort available
Programmable I2C over AUX sequence
Variable eDP signal level and waveform emphsis level by pattern edit
Full resolution: 4096 x 4096
Supporting bitmap (bmp)
High-speed bitmap display in limited pattern number
Signal control by GPIO
Operating Temperature
0 to 40 degree C
*Contents are subject to change without any notice.
